OnePlus 3 Power and Volume Button Flex Repair Guide

OnePlus 3 Power and Volume Button Flex Repair Guide

Power off the phone Take out SIM card tray

Undo two small T2 screws You need two plastic opening tools Slide the tool to open a gap Be careful not to scratch the metal rear cover Then insert another tool

Keep sliding Then you can see a gap here Be careful not to scratch the metal rear cover Then pry up the rear cover on the bottom of the phone Keep prying up

Similar to iPhone here Slide the plastic tool to separate the side of the rear housing Mind the power button Take you efforts The same on the other side

Need some time to remove it There is no adhesive After slide along the rear housing cover You can separate the rear housing and the front screen assembly now Undo 8 Phillips screws

There are 3 small and 5 big screws Remove the metal bracket Remove the wire cable Release connectors of motherboard and charging port flex Battery connector Screen flex connector

Pry out the motherboard Release motherboard flex connector Release the black tape Another side Hold the pull tap of the battery

Take your affords to pull the battery out Black sticker underneath you can see here Show the adhesive here Pry out power button contactor Be careful and do not scratch the frame here

There is some adhesive here The flex comes with the metal contactors Pry it out Separate the cable flex from adhesive underneath And the volume button contactors

This is the power and volume button flex Put a new power and volume button flex in place Make the dot through the hole The new product doesn't come with adhesive If the original adhesive on the frame is not sticky

You can put some tape to the cable flex Make it fit well And don't forget the volume button contactors You can also put some tape on the contactors to protect them Put back motherboard

Make it fit well The front camera Reconnect the screen flex connector Put back battery Make it fit well

Reconnect the charging port flex connector Battery connector Motherboard cable flex Power on the phone Test the power button

Test the volume button Power off Put back metal bracket Tighten up 8 Phillips screws Put the screen assembly back to the rear cover panel Put the top side in first

Pinch down two sides Don’t put too much pressure on it in case you broken the screen Mind the button Pinch down the bottom Check whether the screen works well by power on the phone Check the alert slider and the volume buttons

It works well And the power button Fasten two T2 screws at the bottom in place Put back SIM card tray

Source: Youtube

Md. Elias
admin@test.nygadgetfix.com
No Comments

Sorry, the comment form is closed at this time.

Chat with us
Chat with us
Questions, doubts, issues? We're here to help you!
Connecting...
None of our operators are available at the moment. Please, Send us an email, we will get back to you as soon as possible. Thanks.
Our operators are busy. Please try again later
:
:
:
Have you got question? Write to us!
:
:
This chat session has ended
Was this conversation useful? Vote this chat session.
Good Bad