Huawei P10 lite LCD Display Repair | How-to Video

Huawei P10 lite LCD Display Repair | How-to Video

Wellcome to MyTrendyPhone repair videos Today we show you the step-by-step process of replacing the broken screen on Huawei P10 lite

You can attempt the repair yourself, but we strongly advise you to send your phone to the repair shop MyTrendyPhone cannot be held liable for any potential damage you cause during the DIY repair Let’s see the tools needed for this repair: Philips screwdriver, tweezers, spudgers, and other opening tools, a heating machine or a heat gun, some glue and clamps Of course, you will need a new display You can find all parts and tools at our website, so, check the links in the description

Before you start, always turn the device off, and then remove the sim and SD card tray Start the repair by softening the glue with a heat gun or this heating platform that we have in our repair shop Use a spudger and pry tools to separate the back cover from the frame Cut-through the glue with guitar pics Go slow and gentle, so you won’t break the back cover or damage connections and cables

You’ll have to remove the metal plate that shields the battery connector, in order to unplug the battery The next step is to undo all the top screws, and remove the camera and fingerprint scanner connector shield Then unplug the fingerprint scanner flex cable, and set the back cover aside Proceed with unplugging the display, but first take of the connector shield the same way as before Using the spudger, remove the battery

Do it patiently and be careful not to puncture it, there is a certain risk of fire and explosion Because if to go under the battery, use heat to soften it But do not overheat it Warm-up the frame again to soften the glue that is holding the display Now, you can remove the broken display with spudgers and picks, and take your time there might be a lot of broken glass

When the LCD comes off you should clean the frame and remove the old glue residue Now you can apply fresh glue to the top, bottom and around the edges of the frame Then put the new display on top of it, and connect it with the motherboard After doing that, put the battery back If you haven't done it already now is a good time to remove the old glue residue from the back cover as well

Afterwards, re-connect the fingerprint scanner flex cable, and put the shield on top Also screw-back the display connector shield Then plug in the battery, and put the shield on top It’s time to put the glue on the back of the frame Be precise and don’t use too much glue

Now, set up a car on top, and use clamps to put pressure on the back cover, and the LCD as well Use as many as possible, and leave them on for up to 48 hours And voila, the repair is done!!! Now we have a working LCD Remember, you can order parts, tools and repairs at wwwmytrendyphone

eu Thanks for watching!

Source: Youtube

Md. Elias
admin@test.nygadgetfix.com
No Comments

Sorry, the comment form is closed at this time.

Chat with us
Chat with us
Questions, doubts, issues? We're here to help you!
Connecting...
None of our operators are available at the moment. Please, Send us an email, we will get back to you as soon as possible. Thanks.
Our operators are busy. Please try again later
:
:
:
Have you got question? Write to us!
:
:
This chat session has ended
Was this conversation useful? Vote this chat session.
Good Bad